Got the inboard and outboard trailing edges fit up and pilot hole drilled tonight. The fit up was fairly easy and straight. I'll need to close up the trailing edge angle a bit before fitting up the topside. I can't rivet the bottom side until I route the fuel lines. Notched the inboard edge at the rear channel. I'm going to wait to trim the trailing edge taper for now. A3 pilot holes along the rear channel. Outboard half of the wing will be upsized to A4, inboard to A5 Outboard trailing edge will get trimmed to match the wingtip. I'll need to get it out of storage and prep it for fitting too. Not a huge update tonight, but progress is progress. Stay tuned for more, thanks as always for following along.
0 Comments
Leave a Reply. |
New here? Try starting at:AuthorHusband, father and 911 dispatcher. Long time pilot with a licence that burns a hole in my pocket where my student loan money used to be. First time aircraft builder. Looking to fly my own airplane. Categories
All
Archives
April 2021
build log
|